Difference between revisions of "Using LinMot linear actuator with IONI servo drive"

Revision as of 12:05, 24 January 2016

Most (if not all) LinMot linear actuators can be used with IONI Pro drives because the drive supports driving of three and two phase motors as well as SinCos feedback devices. This page gives instructions of setting up drive for them.

Connections

Typical LinMot actuator has two phase windings and analog sine & cosine outputs as position feedback. For example many actuators have following wires:

• Ph 1+
• Ph 1-
• Ph 2+
• Ph 2-
• +5VDC
• GND
• Sine
• Cosine
• Temp
• Shield

Wire mapping to IONI Pro drive goes as follows:

Motor connector

• Ph 1+ -> PHASE1
• Ph 1- -> PHASE2
• Ph 2+ -> PHASE3
• Ph 2- -> PHASE4
• Shield -> GND

Encoder connector

• +5VDC -> 5V_OUT
• GND -> GND
• Sine -> CHA+
• Cosine -> CHB+
• Temp -> no connection

Parameters

The key parameter is to set motor in correct mode and setup feedback device correctly. For two phase motor, choose:

• Motor typeMT -> 2 phase AC/BLDC
• Pole countMPC -> 2
• Feedback deviceFBD -> SinCos encoder 256X
• Feedback device resolutionFBR -> 256 PPR
• Invert feedback directionFBI -> try both settings and see which one works

Other motor parameters configured according to motor manufacturer specs. To test configuration, set drive in torque mode and try motor with different torque setpoints (Granity testing tab). If motor produces force over it's travel distance, the settings are correct. If motor locks at some position, invert FBI.

The rest of work is to proceed with Servo motor tuning guide.