Tuning tab

From Granite Devices Knowledge Wiki
< Granity user guide(Redirected from TRA1)
Jump to: navigation, search
GranityTuning.png

Tuning tab serves following purposes:

  • Adjust torque control bandwidth
  • Tune velocity controller gains
  • Tune position controller gains

See also:

Parameters[edit | edit source]

Torque controller[edit | edit source]

Short GUI name GUI name Description How to use
TBW Torque bandwidth limit Sets the low pass filter frequency for torque controller setpoint signal Limiting torque bandwidth to a certain level may have several advantages:
  • Improve tuning of velocity or position mode
  • Reduce motor audible noise 1
  • Smoothen motion

Try various values to find the optimum for your system. Typically higher value allows setting higher velocity and position P gains giving more servo stiffness. Typically the optimum bandwidths are between 220-1500 Hz.

If you wish to check torque controller step response in testing tab, then before testing set this value to maximum and also untick Goals/CIS.

1) The best things to try are: reduce MR and ML parameter values and use TBW parameter value 100-680hz. I.e. Try reducing MR/ML by 50% or more. Reduction on these values affect directly the torque controller gains, and every time the values are halved, noise reduces 6dB but you’ll also lose some torque bandwidth. Luckily the full 3khz+ bandwidth is not necessary in most cases, so effect might be just reduction of noise. Setting TBW to 100-680 Hz activates software filtering of current sense signals thus it will also reduce the hiss.

Velocity controller gains[edit | edit source]

Short GUI name GUI name Description How to use
KVP Velocity P gain The proportional gain of velocity controller See Servo motor tuning guide.
KVI Velocity I gain The integral gain of velocity controller
VFF Velocity feed-forward gain Velocity feed-forward gain
AFF Acceleration feed-forward gain Acceleration feed-forward gain

Position controller gains[edit | edit source]

Short GUI name GUI name Description How to use
KPP Position P gain The proportional gain of position controller See Servo motor tuning guide.
PFF Position feed-forward gain Sets feed foward gain from position setpoint to velocity setpoint Adjust to minimize position response overshooting.
AD Anti-dither Motor dithering/zero error hunting reduction function (in current firmware: no effect) Useful in future firmware

Torque cogging & ripple compensation[edit | edit source]

Short GUI name GUI name Description How to use
TRF1 Cogging compensation function Selects the function of compensator See Configuring cogging torque compensation
TRA1 Cogging compensation current Adjusts the amplitude of summed compensating torque command
TRF2 Torque ripple compensation function Selects the function of compensator
TRA2 Torque ripple compensation amplitude Adjust the modulation depth of compensator




In no event the Product Information or parts hereof shall be regarded as guarantee of conditions or characteristics. The Product Information or any part thereof may also not be regarded as a warranty of any kind. No liability of any kind shall be assumed by Author with respect to Product Information or any use made by you thereof, nor shall Author indemnify you against or be liable for any third party claims with respect to such information or any use thereof.

As content of this Wiki may be edited by user community, Granite Devices Oy or it's affiliates do not take any responsibility of the contents of this Wiki. Use information at your own risk. However, Granite Devices staff attempts to review all changes made to this Wiki and keep information trustworthy.

Without written consent, Granite Devices' Products or Intellectual Property shall not be used in situations or installations where living beings, material property, or immaterial property could be harmed by the operation, features or failures of Product. Products may only be used in a way where hazards like moving parts, electric shock, laser radiation, or fire can't be realized even if the content of this Wiki would suggest otherwise.