Editing Setting device bus address

All [[SimpleMotion V2]] compatible devices have a settable address that identifies the device on a multidrop communication bus. Each device on the sharint the same bus must have an unique address number to make error free communication possible. For example configuring bus address is required to establish a connection with [[Granity]] software.

If two or more devices are incorrectly set to have same address, packet collisions will happen in the bus causing communication failures.
==Setting bus address various devices==
The method of how address is set depends on device hardware implementation. This chapter lists methods for Granite Devices products.
===Argon===
[[File:Dipswitch.png|thumb|DIP switch of Argon. In this case the DIP has value 01001.]]
[[Argon (servo drive)]] has a 5 channel DIP switch that sets the address.
{| class="wikitable"
|-
! Address !! Termination on !! DIP switch setting (switches from 1 to 5)
|-
| 255 (firmware upgrade mode) || Off || 00000
|-
| 255 (firmware upgrade mode) || On || 00001
|-
| 1 || Off || 00010
|-
| 1 || On || 00011
|-
| 2 || Off || 00100
|-
| 2 || On || 00101
|-
| 3 || Off || 00110
|-
| 3 || On || 00111
|-
| 4 || Off || 01000
|-
| 4 || On || 01001
|-
| 5 || Off || 01010
|-
| 5 || On || 01011
|-
| 6 || Off || 01100
|-
| 6 || On || 01101
|-
| 7 || Off || 01110
|-
| 7 || On || 01111
|-
| 8 || Off || 10000
|-
| 8 || On || 10001
|-
| 9 || Off || 10010
|-
| 9 || On || 10011
|-
| 10 || Off || 10100
|-
| 10 || On || 10101
|-
| 11 || Off || 10110
|-
| 11 || On || 10111
|-
| 12 || Off || 11000
|-
| 12 || On || 11001
|-
| 13 || Off || 11010
|-
| 13 || On || 11011
|-
| 14 || Off || 11100
|-
| 14 || On || 11101
|-
| 15 || Off || 11110
|-
| 15 || On || 11111
|-
|}