Difference between revisions of "Intensify Nx50 setup guide"
From Granite Devices Knowledge Wiki
| [checked revision] | [checked revision] |
(→Wiring) |
(→Wiring) |
||
| Line 3: | Line 3: | ||
==Overview== | ==Overview== | ||
==Wiring== | ==Wiring== | ||
| + | ===CMD connector=== | ||
| + | CMD connector is a 10 pin flat ribbon cable connector with 0.1"/2.54 mm pin pitch and a polarity key. | ||
{| class="wikitable" | {| class="wikitable" | ||
|- | |- | ||
Revision as of 19:39, 13 February 2013
Intensify Nx50 PCB from top side
This is the intallation & user guide for the Intensify Nx50 laser diode driver. Read it through before operating the device.
Contents
Overview
Wiring
CMD connector
CMD connector is a 10 pin flat ribbon cable connector with 0.1"/2.54 mm pin pitch and a polarity key.
| Header text | Header text | Header text |
|---|---|---|
| 1 | PULSE | Pulse control. When low, output low current and when high, output setpoint current. |
| 2 | GNDA | Analog ground |
| 3 | IMON+ | Current monitor positive output (differential) |
| 4 | IMON- | Current monitor negative output (differential) |
| 5 | VMON+ | Voltage monitor positive output (differential) |
| 6 | VMON- | Voltage monitor negative output (differential) |
| 7 | ISET+ | Current setpoint positive input (differential) |
| 8 | ISET- | Current setpoint negateive input (differential) |
| 9 | ENABLE | Enable input. When low, output enabled and high or open, output disabled. |
| 10 | GND | Power & digital ground |
