Argon user guide

This is the official and latest setup guide of Argon (servo drive). Read it through before attempting to operate Argon.

NOTE: This guide attempts to be as complete and precise as humanly possible, however it can never be perfect. Writers of this guide are not responsibe lf possible damages or losses caused by mistakes or lacks of this guide.

IMPORTANT: Argon drive should be installed and operated only by qualified electricians. Dangerous voltages and mechanics are involved and possiblity of severe injury or even death is possible in case of installation or usage errors.

CURRENT STATUS: This guide is work in progress and should not be followd until this notice has been removed.

Argon introduction

Argon is a servo motor drive designed by Granite Devices. If you are not familiar with the features and specifications of the drive, see following articles:

• Argon (servo drive) - overview & features
• Argon specifications - electrical, physical and operating condition specs

Preparations

Setup process overview

The setup process is straightforward and kept as understandable as possible. In short the process goes as follows:

1. Power up drive's logic voltage and test connection to Granity Argon setup software
2. Make all necessary wiring to motor, AC mains and controller
3. Once wired, connect again with Granity to make paramerization & servo tuning
4. Finalize setup

In case of troubles, refer to troubleshooting chapter and articles in troubleshooting category

Troubleshooting

Led blinking sequences

In no event the Product Information or parts hereof shall be regarded as guarantee of conditions or characteristics. The Product Information or any part thereof may also not be regarded as a warranty of any kind. No liability of any kind shall be assumed by Author with respect to Product Information or any use made by you thereof, nor shall Author indemnify you against or be liable for any third party claims with respect to such information or any use thereof.

As content of this Wiki may be edited by user community, Granite Devices Oy or it's affiliates do not take any responsibility of the contents of this Wiki. Use information at your own risk. However, Granite Devices staff attempts to review all changes made to this Wiki and keep information trustworthy.

Without written consent, Granite Devices' Products or Intellectual Property shall not be used in situations or installations where living beings, material property, or immaterial property could be harmed by the operation, features or failures of Product. Products may only be used in a way where hazards like moving parts, electric shock, laser radiation, or fire can't be realized even if the content of this Wiki would suggest otherwise.