Difference between revisions of "Argon firmware releases"

From Granite Devices Knowledge Wiki
Jump to: navigation, search
[checked revision][checked revision]
Line 39: Line 39:
 
*Space vector modulation code cleanup
 
*Space vector modulation code cleanup
 
*Default motor direction is inverted compared to the earlier versions (tick [[AXI]] to set it same way it was before this version)
 
*Default motor direction is inverted compared to the earlier versions (tick [[AXI]] to set it same way it was before this version)
|| || Important in some cases
+
|| A requirement for [[Granity]] 1.0.2 || Important in some cases, upgrade highly recommended
  
 
|}
 
|}
  
 
[[Category:Argon]]
 
[[Category:Argon]]

Revision as of 17:56, 18 September 2013

This page lists the official firmware releases of the Argon (servo drive) and the change log.

Glossary
  • Firmware package - a firmware file with .gdf name extension that contains combined firmware for Argon I/O side processor and GraniteCore processor
  • I/O side - the I/O side processor of Argon. The source code of this processor is open source.
  • GraniteCore - the motion control processor inside the Argon.
  • Change log - the list of changes made since the previous package version.
  • Remarks - Notes
Firmware package version Date I/O side version GraniteCore version Change log Remarks Importance
0.9.0 1.7.2013 1000 1000 Development version Shipped with the first production batch
1.0.0 download 1.9.2013 1000 1005 Initial official release A requirement for Granity 1.0.0
1.0.1 download 3.9.2013 1000 1006
  • Add STAT_STO_ACTIVE statusbit
  • Incremental setpoint change now changes also absolute setpoint readout value
A requirement for Granity 1.0.1 Functional
1.0.2 Not yet online x.9.2013 1001 1007

New features:

  • Analog in setpoint now has direction input to support 0-10V sources
  • New AC/BLDC motor phasing algorithm with improvements when:
    • Axis is heavy to move
    • Axis is lies at the end of travel during power-on. Now it's possible to use Hall-sensorless phasing when axis lies at the end of travel. Requires limit switches on axis.
  • Feature to invert the polarity of motor positive/negative direction. Parameter AXI on Granity.

Bug fixes:

  • Hall sensor support fixed
  • Failure of phasing under high friction fixed
  • Toggling of general purpose input lines no longer clear faults in case of clear faults signal is constantly on while other signals change state
  • Limit switches now work properly in torque control mode

Adjustments:

  • Goal deviation default fault filter time reduced from 0.2 to 0.1 s
  • Space vector modulation code cleanup
  • Default motor direction is inverted compared to the earlier versions (tick AXI to set it same way it was before this version)
A requirement for Granity 1.0.2 Important in some cases, upgrade highly recommended