Editing Argon user guide/Earthing
| Your changes will be displayed to readers once an authorized user accepts them. (help) |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
| Latest revision | Your text | ||
| Line 1: | Line 1: | ||
Connecting a protective earth to Argon drive is the most crucial single connection to be made: | Connecting a protective earth to Argon drive is the most crucial single connection to be made: | ||
*'''Earthing through the J4 PE terminal''' (always required) | *'''Earthing through the J4 PE terminal''' (always required) | ||
| − | + | *'''Earthing the device case''' (highly recommended and may be required by regulations in some countries) | |
| − | *'''Earthing the device case''' ( | + | |
{{electricshock|Supplying power to the drive '''without proper earthing''' will allow leakage current to raise voltage potential of the device case to hazardous levels. Also ELV circuits (the other ports than J4) may become hazardous without earthing.}} | {{electricshock|Supplying power to the drive '''without proper earthing''' will allow leakage current to raise voltage potential of the device case to hazardous levels. Also ELV circuits (the other ports than J4) may become hazardous without earthing.}} | ||
| Line 33: | Line 32: | ||
===Verifying connection=== | ===Verifying connection=== | ||
After wiring, verify electrical connection by using a resistance meter between the case PE wire and J4 PE terminal while J4 PE wire is not connected. | After wiring, verify electrical connection by using a resistance meter between the case PE wire and J4 PE terminal while J4 PE wire is not connected. | ||
| − | |||
| − | |||
