Editing Commissioning of KANZ servo motors
Your changes will be displayed to readers once an authorized user accepts them. (help) |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 9: | Line 9: | ||
File:Kanz termination4.jpg|Minimum length of wire ends to fit single EMI suppression core to leads. Note: it recommended to strip outer insulation before crimping. | File:Kanz termination4.jpg|Minimum length of wire ends to fit single EMI suppression core to leads. Note: it recommended to strip outer insulation before crimping. | ||
</gallery> | </gallery> | ||
− | {{electricshock|Ensure that insulation of inner wires have not been damaged in the process of wire stripping and that there is no loose wire strands }} | + | {{electricshock|Ensure that insulation of inner wires have not been damaged in the process of wire stripping and termination and that there is no loose wire strands }} |
===Connecting=== | ===Connecting=== | ||
First, ensure that you have understood [[Argon user guide/Wiring|Argon user guide wiring section]] and especially [[Argon user guide/Earthing|earthing section]] before proceeding with installation. | First, ensure that you have understood [[Argon user guide/Wiring|Argon user guide wiring section]] and especially [[Argon user guide/Earthing|earthing section]] before proceeding with installation. | ||
Line 29: | Line 29: | ||
{{tip|Pre-made motor configuration files may have significantly different motor resistance {{param|MR}} and inductance {{param|ML}} values compared to motor data sheet. Pre-made files are hand-optimized to give better performance than entering values from data sheet, so it is recommended to leave these values untouched.}} | {{tip|Pre-made motor configuration files may have significantly different motor resistance {{param|MR}} and inductance {{param|ML}} values compared to motor data sheet. Pre-made files are hand-optimized to give better performance than entering values from data sheet, so it is recommended to leave these values untouched.}} | ||
− | |||
− |