Editing DCtool
Your changes will be displayed to readers once an authorized user accepts them. (help) |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 4: | Line 4: | ||
DualDC operating mode allows driving two independent brush DC servo axis on single VSD-E/XE drive. | DualDC operating mode allows driving two independent brush DC servo axis on single VSD-E/XE drive. | ||
==How to use DualDC== | ==How to use DualDC== | ||
− | #Get DCtool/GDFlasher package from | + | #Get DCtool/GDFlasher package from [http://granitedevices.fi/index.php?q=downloads GD downloads page] |
− | #Install DualDC firmware to | + | #Install DualDC firmware to drive by using supplied GDflasher software. Needed firmware file is supplied in the same software package. |
#Start DCtool to configure the drive. Do not connect GDtool to drive when DualDC FW is loaded. | #Start DCtool to configure the drive. Do not connect GDtool to drive when DualDC FW is loaded. | ||
For detailed instructions, please refer to [http://granitedevices.fi/assets/files/vsd-e_160_dualdc_manual.pdf VSD-E/XE DualDC manual]. | For detailed instructions, please refer to [http://granitedevices.fi/assets/files/vsd-e_160_dualdc_manual.pdf VSD-E/XE DualDC manual]. | ||
− | |||
− |