Editing Granity user guide/Uploading a firmware
Your changes will be displayed to readers once an authorized user accepts them. (help) |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 1: | Line 1: | ||
This article will instruct upgrading the device firmware file by using [[Granity]] software. | This article will instruct upgrading the device firmware file by using [[Granity]] software. | ||
− | {{Tip|Fact of the day: not a single Granite Devices product | + | {{Tip|Fact of the day: not a single Granite Devices product has been harmed by firmware upgrade attempts. The upgrade process is fault tolerant by design.}} |
==Preparations== | ==Preparations== | ||
#Back-up target device settings to file as firmware upgrade may reset them to factory defaults | #Back-up target device settings to file as firmware upgrade may reset them to factory defaults | ||
Line 21: | Line 21: | ||
#After clicking ''Open'', the firmware upload starts immediately. After the process has been completed, click ''Close''. You may now restore your normal SMV2 bus address, restart device and connect normally. Alternatively you may connect right away without restart but the device will have a temporary address of 16 (Argon only, IONI will have it's original address) before the next power cycle.<br/>[[File:firmwareupgradedone.png]] | #After clicking ''Open'', the firmware upload starts immediately. After the process has been completed, click ''Close''. You may now restore your normal SMV2 bus address, restart device and connect normally. Alternatively you may connect right away without restart but the device will have a temporary address of 16 (Argon only, IONI will have it's original address) before the next power cycle.<br/>[[File:firmwareupgradedone.png]] | ||
{{tip|If connection fails in the middle of upgrade, refer to [[Device connection troubleshooting]]}} | {{tip|If connection fails in the middle of upgrade, refer to [[Device connection troubleshooting]]}} | ||
− |