Editing Granity user guide/Uploading a firmware
| Your changes will be displayed to readers once an authorized user accepts them. (help) |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
| Latest revision | Your text | ||
| Line 11: | Line 11: | ||
==The procedure to upgrade firmware on the device== | ==The procedure to upgrade firmware on the device== | ||
Uploading a new firmware to the drive using [[Granity]] software may be done by following the steps below. | Uploading a new firmware to the drive using [[Granity]] software may be done by following the steps below. | ||
| − | #Power-off the target device | + | #Power-off the target device (follow 1 or 2 depending which drive model you have): |
| − | + | ##For [[Argon|ARGON]] drive, read: [[Setting device bus address|Set target device SimpleMotion V2 bus address]] to 255 which is the device firmware upgrade (DFU) mode address. Then power-up the drive 24V voltage. Then click Connect to drive button. | |
| − | ##For [[Argon|ARGON]] drive, read: [[Setting device bus address|Set target device SimpleMotion V2 bus address]] to 255 which is the device firmware upgrade (DFU) mode address. Then power-up the drive 24V voltage. Then click | + | ##For [[IONI]] drive, connect normally with Granity and Click Install firmware button. If device do not shop up in firmware upgrade mode, remove all other IONI drives from IONICUBE and try again. |
| − | ##For [[IONI]] drive, connect normally with Granity and Click | + | #A list of available devices should pop-up: <br>[[File:firmwareupgradeconnect.png]] |
| − | #A list of available devices should pop-up: <br | + | #Choose the one with address from 251 to 255 and click Open |
| − | #Choose the one with address from 251 to 255 and click | + | #The firmware upgrade dialog pops up, choose Open file & start upgrade button<br>[[File:firmwareupgradeconnect2.png]] |
| − | #The firmware upgrade dialog pops up, choose | + | #A file selector dialog pops up, choose the firmware file to be uploaded. Make sure it is meant for your device model:<br>[[File:firmwareupgradefiledialog.png]] |
| − | #A file selector dialog pops up, choose the firmware file to be uploaded. Make sure it is meant for your device model:<br | + | #After clicking Open, the firmware upload starts immediately. After the process has been completed, click Close. You may now restore your normal SMV2 bus address, restart device and connect normally. Alternatively you may connect right away without restart but the device will have a temporary address of 16 (Argon only, IONI will have it's original address) before the next power cycle.<br>[[File:firmwareupgradedone.png]] |
| − | #After clicking | + | |
| − | + | ||
| − | + | ||
