Editing IONICUBE 1X
Your changes will be displayed to readers once an authorized user accepts them. (help) |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 23: | Line 23: | ||
*20 pin ribbon cable connector for I/O and [[setpoint]] signals | *20 pin ribbon cable connector for I/O and [[setpoint]] signals | ||
*Support 3.3V, 5V and 24V<sup>1</sup> I/O signal levels | *Support 3.3V, 5V and 24V<sup>1</sup> I/O signal levels | ||
− | * | + | *Charge-pump enable input for safety |
*E-stop switch input ([[safe torque off]]) | *E-stop switch input ([[safe torque off]]) | ||
*[[IONICUBE]] and [[ARGON Servo Drive]] compatible encoder connector pin-out | *[[IONICUBE]] and [[ARGON Servo Drive]] compatible encoder connector pin-out | ||
Line 44: | Line 44: | ||
==See also== | ==See also== | ||
* [[IONICUBE]] - 4 axis motherboard for IONI | * [[IONICUBE]] - 4 axis motherboard for IONI | ||
− | |||
− | |||
− |