Editing IONICUBE 1X
| Your changes will be displayed to readers once an authorized user accepts them. (help) |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
| Latest revision | Your text | ||
| Line 21: | Line 21: | ||
*Support mechanical end-of-travel switches and homing switch | *Support mechanical end-of-travel switches and homing switch | ||
*Motor holding brake output with driver | *Motor holding brake output with driver | ||
| − | * | + | *26 pin ribbon cable connector for I/O and [[setpoint]] signals |
*Support 3.3V, 5V and 24V<sup>1</sup> I/O signal levels | *Support 3.3V, 5V and 24V<sup>1</sup> I/O signal levels | ||
*[[Charge pump enable input]] for safety | *[[Charge pump enable input]] for safety | ||
| Line 44: | Line 44: | ||
==See also== | ==See also== | ||
* [[IONICUBE]] - 4 axis motherboard for IONI | * [[IONICUBE]] - 4 axis motherboard for IONI | ||
| − | |||
| − | |||
| − | |||
