Difference between revisions of "IONI hardware revisions"

From Granite Devices Knowledge Wiki
Jump to: navigation, search
[checked revision][checked revision]
(add see also)
 
(4 intermediate revisions by the same user not shown)
Line 43: Line 43:
 
|
 
|
 
* On corner of PCB behind LEDs is small print reading V029R0
 
* On corner of PCB behind LEDs is small print reading V029R0
 +
|}
 +
==Next revisions==
 +
{| class="wikitable"
 +
|-
 +
! Release date !! Models !! PCB version
 +
!Component configuration!! Changes & Impact
 +
!How to identify
 
|-
 
|-
|Planned changes
+
|TBD
|Any
+
|N/A
|Any
+
|N/A
|Any
+
|N/A
|No foreseeable change plans at the moment
+
|No revision change plans at the moment
 
|
 
|
 
|}
 
|}
 +
 +
== See also ==
 +
* [[IONICUBE hardware revisions]]
 
[[Category:IONI]]
 
[[Category:IONI]]

Latest revision as of 15:11, 31 October 2017

PCB version print on the corner. This is from PCB026.

List IONI drive hardware revisions and changes.

Release date Models PCB version Component configuration Changes & Impact How to identify
5.2015 IONI, IONI Pro, IONI Pro HC V26 Initial version Initial release
  • Component RN5 has value 221
  • On corner of PCB behind LEDs is small print reading PCB026
1.2017 IONI, IONI Pro V26 V6
  • Changed voltage sense resistor value to have equal value with other models
    • No practical effect for end user
  • Changed GPI1,2,3 series resistors from 220 ohm to 68 ohm
    • Improve clock signal strength with BiSS and SSI encoders
  • Component RN5 has value 680
  • On corner of PCB behind LEDs is small print reading PCB026
1.2017 IONI Pro HC V26 V6
  • Changed GPI1,2,3 series resistors from 220 ohm to 68 ohm
    • Improve clock signal strength with BiSS and SSI encoders
  • Component RN5 has value 680
  • On corner of PCB behind LEDs is small print reading PCB026
1.2017 IONI, IONI Pro, IONI Pro HC V29 V6
  • New PCB revision with reduced encoder to current sense crosstalk
    • In high inductance motors may reduced motor audible noise. Crosstalk is reduced by approximately 10 dB.
  • Added 3300 ohm 5V pull-up resistor to GPI5 input
    • Originally GPI5 was pulled up by >30kOhm resistor to 3.3V
  • On corner of PCB behind LEDs is small print reading V029R0

Next revisions[edit | edit source]

Release date Models PCB version Component configuration Changes & Impact How to identify
TBD N/A N/A N/A No revision change plans at the moment

See also[edit | edit source]