Intensify Nx50 setup guide

From Granite Devices Knowledge Wiki
Revision as of 19:39, 13 February 2013 by Tero K (Talk | contribs) (Wiring)


Jump to: navigation, search
Intensify Nx50 PCB from top side

This is the intallation & user guide for the Intensify Nx50 laser diode driver. Read it through before operating the device.

Overview

Wiring

CMD connector

CMD connector is a 10 pin flat ribbon cable connector with 0.1"/2.54 mm pin pitch and a polarity key.

Header text Header text Header text
1 PULSE Pulse control. When low, output low current and when high, output setpoint current.
2 GNDA Analog ground
3 IMON+ Current monitor positive output (differential)
4 IMON- Current monitor negative output (differential)
5 VMON+ Voltage monitor positive output (differential)
6 VMON- Voltage monitor negative output (differential)
7 ISET+ Current setpoint positive input (differential)
8 ISET- Current setpoint negateive input (differential)
9 ENABLE Enable input. When low, output enabled and high or open, output disabled.
10 GND Power & digital ground

Differential signals

Connecting parallel

Usage

Basic usage

Pulsed usage

Monitoring


In no event the Product Information or parts hereof shall be regarded as guarantee of conditions or characteristics. The Product Information or any part thereof may also not be regarded as a warranty of any kind. No liability of any kind shall be assumed by Author with respect to Product Information or any use made by you thereof, nor shall Author indemnify you against or be liable for any third party claims with respect to such information or any use thereof.

As content of this Wiki may be edited by user community, Granite Devices Oy or it's affiliates do not take any responsibility of the contents of this Wiki. Use information at your own risk. However, Granite Devices staff attempts to review all changes made to this Wiki and keep information trustworthy.

Without written consent, Granite Devices' Products or Intellectual Property shall not be used in situations or installations where living beings, material property, or immaterial property could be harmed by the operation, features or failures of Product. Products may only be used in a way where hazards like moving parts, electric shock, laser radiation, or fire can't be realized even if the content of this Wiki would suggest otherwise.