Measure motor resistance and inductance in Granity

From Granite Devices Knowledge Wiki
Revision as of 10:26, 16 April 2015 by Tero K (Talk | contribs)


Jump to: navigation, search
The definition of inductance
Granity setup software has a motor resistance and inductance measurement function that works with IONI drives.

Using automatic measure is the new recommended approach to set MR and ML parameters accurately even when motor data sheet would provide these values. This is because many data sheets unfortunately provide inaccurate values. Some manufacturers have apparently characterized motor inductance at high frequency range (hundreds of kHz) which typically gives a value more than 50% off from the real inductance in typical laminated iron motors.

Checklist

To successfully measure, following conditions must be met:

  • Motor type selected
  • Motor connected and parameterized (except MR and ML can be any value)
  • Power on and enabled (any control mode)
  • If Brush DC motor, motor shaft must be mechanically locked in place

Device status must have all of following bits on:

  • Initialized
  • Enabled
  • Run
  • Voltages good

Device status must NOT have any of the following bits on:

  • Fault stopped
  • STO active
  • Permanent stop
  • Error recovering
  • Homing

Execution

To start measurement, click "Measure resistance & inductance" button. The procedure takes about 10 seconds to complete and if sucessfull, the MR and ML parameters will be updated by the measured values.

MeasureRL.png


In no event the Product Information or parts hereof shall be regarded as guarantee of conditions or characteristics. The Product Information or any part thereof may also not be regarded as a warranty of any kind. No liability of any kind shall be assumed by Author with respect to Product Information or any use made by you thereof, nor shall Author indemnify you against or be liable for any third party claims with respect to such information or any use thereof.

As content of this Wiki may be edited by user community, Granite Devices Oy or it's affiliates do not take any responsibility of the contents of this Wiki. Use information at your own risk. However, Granite Devices staff attempts to review all changes made to this Wiki and keep information trustworthy.

Without written consent, Granite Devices' Products or Intellectual Property shall not be used in situations or installations where living beings, material property, or immaterial property could be harmed by the operation, features or failures of Product. Products may only be used in a way where hazards like moving parts, electric shock, laser radiation, or fire can't be realized even if the content of this Wiki would suggest otherwise.