Servo motor torque mode test

From Granite Devices Knowledge Wiki
Revision as of 12:33, 21 August 2017 by Esa (Talk | contribs)


Jump to: navigation, search

Main idea

The servo motor torque mode test is a method to verify that basic parameters and wiring are correct. The target is to rotate/move the motor in torque mode in a continuous manner.

Assumptions

  • All wiring are triple checked and torque tuning is done properly.
    • Refer to the product user guidebook for detailed wiring instructions.
    • Pay special attention to encoder operating voltage (VCC) and GND wiring. Wiring VCC and GND erroneously may damage the encoder.
  • The motor is free to move/rotate, and no harm nor damages can happen from a long continuous movement.


Steps

  1. Read servo tuning basics to get understanding how servo motors work.
  2. Set the drive in Torque mode from Granity.
  3. Follow the torque controller tuning instructions.
  4. Increase the target setpoint to get the motor moving.
    1. Go to Granity/Testing tab.
    2. Make sure that the setpoint is zero and the drive is enabled and ready.
    3. Set the [TSP1] Target setpoint 1 to 500.
    4. Increase the target setpoint slowly by clicking the "Increment by TSP1" button and checking whether the motor moves of not.
    5. If the motor moves in a continuous manner, all parameters and wiring are correct.

Troubleshooting

In most cases, the motor halts after a short movement if the feedback resolution is incorrect, or if it's direction is reversed.

  • Check wiring, especially logic and motor voltages, Enable, and STO.
  • Check FBI Invert feedback direction checkbox in Granity/Machine tab, and repeat the steps above.
    • This inverts the encoder direction without the need for rewiring.
  • Check the motor pole count and encoder resolution from their datasheets.
  • Move the motor by known angle/distance, and check the position feedback reading from Granity/Testing tab.
    • The position feedback value is always in CPR (counts per revolution). From this, the correct PPR can be calculated for one revolution (PPR = CPR/4).

Further reading

After the torque mode is configured and the motor can be controlled in torque mode properly, velocity and/or position modes can be tuned. Please refer to their respective instruction pages for further details.

Other motor types


In no event the Product Information or parts hereof shall be regarded as guarantee of conditions or characteristics. The Product Information or any part thereof may also not be regarded as a warranty of any kind. No liability of any kind shall be assumed by Author with respect to Product Information or any use made by you thereof, nor shall Author indemnify you against or be liable for any third party claims with respect to such information or any use thereof.

As content of this Wiki may be edited by user community, Granite Devices Oy or it's affiliates do not take any responsibility of the contents of this Wiki. Use information at your own risk. However, Granite Devices staff attempts to review all changes made to this Wiki and keep information trustworthy.

Without written consent, Granite Devices' Products or Intellectual Property shall not be used in situations or installations where living beings, material property, or immaterial property could be harmed by the operation, features or failures of Product. Products may only be used in a way where hazards like moving parts, electric shock, laser radiation, or fire can't be realized even if the content of this Wiki would suggest otherwise.