Editing Setting device bus address
Your changes will be displayed to readers once an authorized user accepts them. (help) |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 1: | Line 1: | ||
− | + | All [[SimpleMotion V2]] compatible devices have a settable address that identifies the device on a multidrop communication bus. Each device sharing the same bus must have an unique address number to make error free communication possible. For example configuring bus address is required to establish a connection with [[Granity]] software. | |
− | + | ==Setting bus address== | |
− | + | The method of how address is set depends on device hardware implementation. This chapter lists methods for Granite Devices products. | |
− | + | ||
===Argon=== | ===Argon=== | ||
[[File:Dipswitch.png|thumb|DIP switch of Argon. In this case the DIP has value 01001.]] | [[File:Dipswitch.png|thumb|DIP switch of Argon. In this case the DIP has value 01001.]] | ||
Line 76: | Line 75: | ||
|- | |- | ||
|} | |} | ||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
==Bus termination== | ==Bus termination== | ||
Line 96: | Line 85: | ||
Methods to eliminate the stub on [[SimpleMotion V2 port]] cable E-stop cable if longer than 30cm E-stop cable is needed: | Methods to eliminate the stub on [[SimpleMotion V2 port]] cable E-stop cable if longer than 30cm E-stop cable is needed: | ||
− | *Cut the | + | *Cut the A and B wires from the cable near connector, this ends the RS485 bus next to connector and minimizes stub |
− | *Alternatively, connect termination resistor at end of | + | *Alternatively, connect termination resistor at end of A and B pair and set DIP switch termination off |
==Troubleshooting== | ==Troubleshooting== | ||
Line 104: | Line 93: | ||
*If termination is missing or is present multiple times | *If termination is missing or is present multiple times | ||
*If bus stub is too long | *If bus stub is too long | ||
− | |||
− | |||
− | |||
− | |||
− | |||
− |