Editing SimuCUBE stuck in DFU mode
Your changes will be displayed to readers once an authorized user accepts them. (help) |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 1: | Line 1: | ||
− | If SimuCUBE is always | + | If SimuCUBE is always in DFU mode, then verify the following hardware feature functionality: |
{{picturebox|simuicube_stick_dfu_troubleshooting.jpg|caption=Hardware testing instructions}} | {{picturebox|simuicube_stick_dfu_troubleshooting.jpg|caption=Hardware testing instructions}} | ||
Line 7: | Line 7: | ||
**Reason may be also a solder defect in the switch (bottom of the board), check visually the soldering. It can be also tested by multimeter: measure the resistance between the switch lead and the board golden pad of the same switch lead (for both leads separately). These resistance should be always under 1 Ohm if the soldering is good. | **Reason may be also a solder defect in the switch (bottom of the board), check visually the soldering. It can be also tested by multimeter: measure the resistance between the switch lead and the board golden pad of the same switch lead (for both leads separately). These resistance should be always under 1 Ohm if the soldering is good. | ||
*Unused SimuCUBE from factory will contain a special firmware that will place the device in DFU mode regardless of DIP switch setting. So another reason for persistent DFU mode may be that uploading of main firmware has failed, and the factory default FW is still inside. | *Unused SimuCUBE from factory will contain a special firmware that will place the device in DFU mode regardless of DIP switch setting. So another reason for persistent DFU mode may be that uploading of main firmware has failed, and the factory default FW is still inside. | ||
− | |||
− | |||
− |