Editing SimuCUBE stuck in DFU mode
Your changes will be displayed to readers once an authorized user accepts them. (help) |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 2: | Line 2: | ||
{{picturebox|simuicube_stick_dfu_troubleshooting.jpg|caption=Hardware testing instructions}} | {{picturebox|simuicube_stick_dfu_troubleshooting.jpg|caption=Hardware testing instructions}} | ||
− | + | If the switch fails to make contact (resistance always higher than 1kOhm), then it is the likely reason for the problem. Try to operate switch several times to make possible corrosion to disappear. | |
− | + | ||
− | + | ||
− | + | ||
− | + | ||
− | + | Note: unused SimuCUBE from factory will contain a special firmware that will place the device in DFU mode regardless of DIP switch setting. So another reason for persistent DFU mode may be that uploading of main firmware has failed, and the factory default FW is still inside. | |
− | + |