SimuCUBE stuck in DFU mode

From Granite Devices Knowledge Wiki
Jump to: navigation, search

If SimuCUBE is always stuck in DFU mode, then see the following instructions and notes below.

Simuicube stick dfu troubleshooting.jpg

Hardware testing instructions

Notes

  • If the switch fails to make contact (resistance always higher than 1kOhm), then it is the likely reason for the problem.
    • Try to operate switch several times to make possible corrosion to disappear.
    • Reason may be also a solder defect in the switch (bottom of the board), check visually the soldering. It can be also tested by multimeter: measure the resistance between the switch lead and the board golden pad of the same switch lead (for both leads separately). These resistance should be always under 1 Ohm if the soldering is good.
  • Unused SimuCUBE from factory will contain a special firmware that will place the device in DFU mode regardless of DIP switch setting. So another reason for persistent DFU mode may be that uploading of main firmware has failed, and the factory default FW is still inside.

In no event the Product Information or parts hereof shall be regarded as guarantee of conditions or characteristics. The Product Information or any part thereof may also not be regarded as a warranty of any kind. No liability of any kind shall be assumed by Author with respect to Product Information or any use made by you thereof, nor shall Author indemnify you against or be liable for any third party claims with respect to such information or any use thereof.

As content of this Wiki may be edited by user community, Granite Devices Oy or it's affiliates do not take any responsibility of the contents of this Wiki. Use information at your own risk. However, Granite Devices staff attempts to review all changes made to this Wiki and keep information trustworthy.

Without written consent, Granite Devices' Products or Intellectual Property shall not be used in situations or installations where living beings, material property, or immaterial property could be harmed by the operation, features or failures of Product. Products may only be used in a way where hazards like moving parts, electric shock, laser radiation, or fire can't be realized even if the content of this Wiki would suggest otherwise.