Editing Argon user guide/Making the first Granity connection

Follow the instructions to make the first Granity connection to Argon drive.
==Preparations==
# Download and install the [[Granity]] software. Lates version is downloadable from the link: [http://granitedevices.com/assets/files/granity_setup.exe Granity software] for windows (approx 15 MB)
# Connect PE of [[Argon_wiring#J3_24V_power_and_motor_brake_port|J4 connector]] to protective earth. After that wire 24 VDC power supply to Argon's [[Argon_wiring#J3_24V_power_and_motor_brake_port|J3 connector]], however do not power up yet.
# [[Setting device bus address|Set Argon DIP switches]] to give an bus address to the device. 
# Connect Argon J2.1 connector to [[SimpleMotion V2 USB adapter]] with a straight Ethernet cable and plug USB adapter to computer.
# Power up the 24 VDC power. Some leds should start blinking at the drive ([[Argon user guide/LED indicators|more about blinking sequences]]). 
# Launch Granity software and:
##Go to Connect tab
##Ensure that "SimpleMotion V2 Adapter" is selected from drowdown list called ''Communication interface device''. (note 1)
##Click ''Connect to drive''
##Once list of connected drives pop up, select the one you connected and click ''Open''

Now if everything has gone well, you should see information like drive model and serial number on the Connect tab. Connection has been successfully tested and drive may be disconnected to proceed with next setup step.

Note 1) If multiple choices are named as "SimpleMotion V2 Adapter", then try each of them to find the correct one.