Difference between revisions of "IONICUBE hardware revisions"

[checked revision]

Revision as of 11:29, 2 March 2017

List IONICUBE drive hardware revisions and changes.

Release date	Models	Device revision	Changes & Impact	How to identify
5.2015	IONICUBE	1	Initial version	On board print "IONICUBE Rev 1 (007)"
12.2016	IONICUBE	2	Added Mini USB connector with on-board SimpleMotion V2 bus interface No requirement for external RJ45 cabling or SimpleMotion V2 USB adapter IONICUBE can also act as SimpleMotion master device when other SimpleMotion devices are daisy chained in the RJ45 ports Jumpers replaced by DIP switches Protection diodes for on-board regenerative resistor driver and motor brake driver added Fixed an issue where pin on X axis GPO1 (X5 connector pin 11) logic high voltage was clamped to approximately 2.0 Volts instead of nominal 3.3V output level	On board print "IONICUBE Rev 2 (009)"

@@ Line 3: / Line 3: @@
 {| class="wikitable"
 |-
-! Release date !! Models !! PCB version  !!Changes & Impact!!How to identify
+! Release date !! Models
+!Device revision!!Changes & Impact!!How to identify
 |-
-| 5.2015 || IONICUBE ||  V007 ||Initial version
+| 5.2015 || IONICUBE
+|1||Initial version
+|On board print "IONICUBE Rev 1 (007)"
+|-
+|12.2016
+|IONICUBE
+|2
 |
-* Component RN5 has value 221
+* Added Mini USB connector with on-board SimpleMotion V2 bus interface
-* On corner of PCB behind LEDs is small print reading PCB026
+** No requirement for external RJ45 cabling or [[SimpleMotion V2 USB adapter]]
+** IONICUBE can also act as SimpleMotion master device when other SimpleMotion devices are daisy chained in the RJ45 ports
+* Jumpers replaced by DIP switches
+* Protection diodes for on-board [[regenerative resistor]] driver and motor brake driver added
+* Fixed an issue where pin on X axis GPO1 (X5 connector pin 11) logic high voltage was clamped to approximately 2.0 Volts instead of nominal 3.3V output level
+|On board print "IONICUBE Rev 2 (009)"
 |}
 [[Category:IONICUBE]]
 [[Category:Lists]]