Difference between revisions of "Granity"
From Granite Devices Knowledge Wiki
| [checked revision] | [checked revision] |
(→Design) |
|||
| Line 2: | Line 2: | ||
==Design== | ==Design== | ||
Granity has been redesigned from ground up and aims to deliver effortless setup of servo drives while keeping functionality and reliability maxed out. | Granity has been redesigned from ground up and aims to deliver effortless setup of servo drives while keeping functionality and reliability maxed out. | ||
| + | |||
[[File:Granity3dhires.png|800px]] | [[File:Granity3dhires.png|800px]] | ||
| + | |||
==Download== | ==Download== | ||
Download the latest release from [[Media:GranitySoftware.zip|this direct link]]. To run Granity, just extract the Zip file and launch Granity.exe. Installation is not needed. | Download the latest release from [[Media:GranitySoftware.zip|this direct link]]. To run Granity, just extract the Zip file and launch Granity.exe. Installation is not needed. | ||
Revision as of 20:30, 6 November 2013
Granity is the configuration software tool for Argon (servo drive). Granity is a successor of GDtool software.
Contents
Design
Granity has been redesigned from ground up and aims to deliver effortless setup of servo drives while keeping functionality and reliability maxed out.
Download
Download the latest release from this direct link. To run Granity, just extract the Zip file and launch Granity.exe. Installation is not needed.
Drivers
In most cases Windows detects the SimpleMotion V2 USB adapter as USB Serial port and is able to install drivers automatically. However, if not download VCP (Virtual COM Port) drivers from this page. The recommended package is the setup executable (direct link).
Documentation
See main article Granity user guide
Version history
| Version | Release date | Change log | Remarks |
|---|---|---|---|
| 1.0.0 | 1.9.2013 | Initial release | Requires Argon firmware 1.0.0 |
| 1.0.1 | 3.9.2013 |
|
Requires Argon firmware 1.0.1 |
| 1.0.2 | 18.9.2013 |
|
Requires Argon firmware 1.0.2 |
| 1.1.0 | 6.11.2013 | Requires Argon firmware 1.1.0 |
Bugs and TODO's
Known bugs
- Halls enabled & Granity connected & drive restart -> starts spinning and follow error faults (TODO: verify) - fix attempt done
- Serial numbers read -1 when loading .drc file
- Tab order not correct on all fields
- Communication error is ofter reported after firmware upgrade
Suggested features
- Automatic save/restore settings on FW upgrade
- Display device temperature
- User settable temperature fault level
- Add mm/min and inches/min speed units
- Add zero offset function for Analog & PWM setpoints
