Difference between revisions of "Argon user guide"
| [checked revision] | [checked revision] |
(→What you will need?) |
|||
| Line 35: | Line 35: | ||
*Wire cutter | *Wire cutter | ||
*Windows computer | *Windows computer | ||
| − | + | Skills needed: | |
| + | *Qualified electrician skills (license to make mains AC connections) | ||
| + | *Basic kowledge of servo systems | ||
==Step 1, testing connection to computer== | ==Step 1, testing connection to computer== | ||
==Step 2, wiring== | ==Step 2, wiring== | ||
Revision as of 13:45, 16 December 2012
This is the official and latest setup guide of Argon (servo drive). Read it through before attempting to operate Argon.
NOTE: This guide attempts to be as complete and precise as humanly possible, however it can never be perfect. Writers of this guide are not responsibe lf possible damages or losses caused by mistakes or lacks of this guide.
IMPORTANT: Argon drive should be installed and operated only by qualified electricians. Dangerous voltages and mechanics are involved and possiblity of severe injury or even death is possible in case of installation or usage errors.
CURRENT STATUS: This guide is work in progress and should not be followd until this notice has been removed.
Contents
Argon introduction
Argon is a servo motor drive designed by Granite Devices. If you are not familiar with the features and specifications of the drive, see following articles:
- Argon (servo drive) - overview & features
- Argon specifications - electrical, physical and operating condition specs
Preparations
Setup process overview
The setup process is straightforward and kept as understandable as possible. In short the process goes as follows:
- Power up drive's logic voltage and test connection to Granity Argon setup software
- Make all necessary wiring to motor, AC mains and controller
- Once wired, connect again with Granity to make paramerization & servo tuning
- Finalize setup
In case of troubles, refer to troubleshooting chapter and articles in troubleshooting category
What you will need?
Items needed during this guide:
- Argon drive
- SimpleMotion V2 USB adapter
- 2 or more RJ45 Ethernet cables (Cat 5/5e/6, straight connection, not cross linked)
- Emergencency stop button (normally closed NC type) or equivalent
- Regulated 24 VDC power supply, output capability at least 0.7A per drive
- Servo motor
- Shielded AC power conductors
Optional but highly recommended items:
- Braking resistor
- Ferrite core EMI filters
- AC line EMI filter
Tools needed:
- Screwdriver
- Wire cutter
- Windows computer
Skills needed:
- Qualified electrician skills (license to make mains AC connections)
- Basic kowledge of servo systems
