Difference between revisions of "Simucube 2 documentation"

Revision as of 08:44, 28 May 2024

This page lists all officially published documentation of Simucube 2 systems. The main Simucube 2 product website is at https:///www.simucu.be

Software

see Simucube 2 True Drive software releases

User manuals

• Simucube 2 User Guide (PDF)

Service manuals

Note: Review the instructions carefully and only perform service procedures if you feel comfortable performing them. Your reseller will always help if necessary.

Quick Release Pin is too tight or too loose

Problem: The Quick Release Pin is too tight or too easy to remove and QR has play. Possible solution: Adjust the QR pin tightness. See video here: https://www.youtube.com/watch?v=YYKkb5Ioadg

Quick release slipping

Problem: Wheel/quick release is slipping and center point is changing. Cause: The conical shaft adapter is slipping. This affected many of the very first produced Simucube 2 units in May 2019.

• Tightening Simucube Quick Release (solution to slipping) (PDF)

Device stuck at startup

Problem: Device stuck in "Waiting for drive to get ready" and does not start correctly. The E-stop button status follows the real e-stop button. Possible cause: Internal cable for the power button is placed in a bad/sensitive location inside the device. Note: This service instruction is only applicable to Simucube 2 Sport and Pro R1 units (Pro with 2 power supplies) that were produced before August 2020. R1 units have a rocker switch near the one of the rear corners as a power switch, where as R2 units have a on/off toggle switch near the center of the back plate.

• Simucube 2 Sport/Pro R1 power button wire check (PDF)

Antenna connector / cable issues

Problem: The external antenna connector is loose. Cause: Loose antenna connector. Note: Do not spin the antenna connector to not cause the internal cable to wind up and break.

• Simucube 2 Sport/Pro antenna connection retighten instructions (PDF)
• Simucube 2 Ultimate antenna connector replacement / re-tightening guide (PDF)

Problem: Spinning antenna connector has caused the internal antenna cable to break. Solution: Replace the antenna connector&cable assembly. Contact your reseller for spare parts.

• Simucube 2 Sport/Pro R1 antenna connector replacement guide (PDF)
• Simucube 2 Sport/Pro R2 antenna connector replacement guide (PDF)
• Simucube 2 Ultimate antenna connector replacement / re-tightening guide (PDF)

Using Simucube wheelbase products on Linux

see: Using Simucube wheel base in Linux

Developer documentation

• Simucube 2 Accessory Port Application Guide (PDF)
• Simucube product USB interface documentation