DCtool
DCtool is a setup software for VSD-E and VSD-XE in DualDC operating mode. Compared to GDtool it provides less functionality but also easier setup process.
DualDC operating mode allows driving two independent brush DC servo axis on single VSD-E/XE drive.
How to use DualDC
- Get DCtool/GDFlasher package from
here - Install DualDC firmware to VSD-E or XE drive by using supplied GDflasher software. Needed firmware file is supplied in the same software package.
- Start DCtool to configure the drive. Do not connect GDtool to drive when DualDC FW is loaded.
For detailed instructions, please refer to VSD-E/XE DualDC manual.
In no event the Product Information or parts hereof shall be regarded as guarantee of conditions or characteristics. The Product Information or any part thereof may also not be regarded as a warranty of any kind. No liability of any kind shall be assumed by Author with respect to Product Information or any use made by you thereof, nor shall Author indemnify you against or be liable for any third party claims with respect to such information or any use thereof.
As content of this Wiki may be edited by user community, Granite Devices Oy or it's affiliates do not take any responsibility of the contents of this Wiki. Use information at your own risk. However, Granite Devices staff attempts to review all changes made to this Wiki and keep information trustworthy.
Without written consent, Granite Devices' Products or Intellectual Property shall not be used in situations or installations where living beings, material property, or immaterial property could be harmed by the operation, features or failures of Product. Products may only be used in a way where hazards like moving parts, electric shock, laser radiation, or fire can't be realized even if the content of this Wiki would suggest otherwise.
