Difference between revisions of "Granity"

From Granite Devices Knowledge Wiki
Jump to: navigation, search
[checked revision][checked revision]
m (Text replacement - "\[\[([A-Z]{2,3})\]\]" to "{{param|$1}}")
(Version history)
Line 59: Line 59:
 
*Saving graph raw data to .csv file possible
 
*Saving graph raw data to .csv file possible
 
|}
 
|}
 +
Archived older versions can be downloaded from link: [[File:GranitySoftware.zip]].
  
 
==Bugs and TODO's==
 
==Bugs and TODO's==

Revision as of 11:06, 30 October 2015

Granity is the configuration software tool for Argon (servo drive). Granity is a successor of GDtool software.

Design

From GDtool times, Granity has been redesigned from ground up and aims to deliver effortless setup of servo drives while keeping functionality and reliability maxed out.

Granity3dhires.png

Download

Download the latest release from the link below. To run Granity, just extract the Zip file and launch Granity.exe. Installation is not needed.

Drivers

In most cases Windows detects the SimpleMotion V2 USB adapter as USB Serial port and is able to install drivers automatically. However, if not, download VCP (Virtual COM Port) drivers from this page. The recommended package is the setup executable (direct link).

Documentation

See main article Granity user guide

Version history

Version Release date Change log Remarks
1.0.0 1.9.2013 Initial release Requires Argon firmware 1.0.0
1.0.1 3.9.2013
  • Correct typos
  • Set Abs and Set Inc buttons to change setpoint manually
  • Display list of all parameters together with graphs - becomes useful when saving graphs as the list of parameters gets included in the file as well
  • Safe Torque Off status is now displayed
  • Fix the issue of not showing online version of Wiki
Requires Argon firmware 1.0.1
1.0.2 18.9.2013
  • Added Invert directionAXI parameter
Requires Argon firmware 1.0.2
1.1.0 6.11.2013
  • Added parameters Dynamic braking decelerationBDD, Mech brake engage delayBED and Mech brake assisted phasingBAP
  • Graphs are now saved as PNG image file instead of PDF
  • Added copy device state to clipboard button
  • Avoid getting (harmless) connection error message after FW upgrade
Requires Argon firmware 1.1.0
1.5.0 19.3.2015
  • Support for [[IONI Servo & Stepper Drive added
  • Various usability improvements and added parameters (IONI only, update for Argon coming later)
In this package version there are two executables (Granity-ARGON.exe and Granity-IONI.exe). Use the one intended for your drive model.
1.6.0 15.4.2015
1.7.0 4.5.2015
  • Support SinCos feedback device option for IONI
  • Added more guidance text to certain error messages
1.8.0 preview, not yet official 29.5.2015
  • Support for Argon with firmware 2.0
  • Added sanity checks and guidance for few parameterization errors
  • Saving graph raw data to .csv file possible

Archived older versions can be downloaded from link: File:GranitySoftware.zip.

Bugs and TODO's

Known bugs

  • Halls enabled & Granity connected & drive restart -> starts spinning and follow error faults - fix attempt done
  • Serial numbers read -1 when loading .drc file

Suggested features

  • User settable temperature fault level
  • Add mm/min and inches/min speed units
  • Add zero offset function for Analog & PWM setpoints - can be done by making setpoint scope and calculating average and then the offset value