Difference between revisions of "IONICUBE hardware revisions"
From Granite Devices Knowledge Wiki
| [checked revision] | [checked revision] |
(Created page with "List IONICUBE drive hardware revisions and changes. {| class="wikitable" |- ! Release date !! Models !! PCB version !!Changes & Impact!!How to identify |- | 5.2015 || IO...") |
(Tag: VisualEditor) |
||
| Line 3: | Line 3: | ||
{| class="wikitable" | {| class="wikitable" | ||
|- | |- | ||
| − | ! Release date !! Models ! | + | ! Release date !! Models |
| + | !Device revision!!Changes & Impact!!How to identify | ||
|- | |- | ||
| − | | 5.2015 || IONICUBE | | + | | 5.2015 || IONICUBE |
| + | |1||Initial version | ||
| + | |On board print "IONICUBE Rev 1 (007)" | ||
| + | |- | ||
| + | |12.2016 | ||
| + | |IONICUBE | ||
| + | |2 | ||
| | | | ||
| − | * | + | * Added Mini USB connector with on-board SimpleMotion V2 bus interface |
| − | * | + | ** No requirement for external RJ45 cabling or [[SimpleMotion V2 USB adapter]] |
| + | ** IONICUBE can also act as SimpleMotion master device when other SimpleMotion devices are daisy chained in the RJ45 ports | ||
| + | * Jumpers replaced by DIP switches | ||
| + | * Protection diodes for on-board [[regenerative resistor]] driver and motor brake driver added | ||
| + | * Fixed an issue where pin on X axis GPO1 (X5 connector pin 11) logic high voltage was clamped to approximately 2.0 Volts instead of nominal 3.3V output level | ||
| + | |On board print "IONICUBE Rev 2 (009)" | ||
|} | |} | ||
[[Category:IONICUBE]] | [[Category:IONICUBE]] | ||
[[Category:Lists]] | [[Category:Lists]] | ||
Revision as of 11:29, 2 March 2017
List IONICUBE drive hardware revisions and changes.
| Release date | Models | Device revision | Changes & Impact | How to identify |
|---|---|---|---|---|
| 5.2015 | IONICUBE | 1 | Initial version | On board print "IONICUBE Rev 1 (007)" |
| 12.2016 | IONICUBE | 2 |
|
On board print "IONICUBE Rev 2 (009)" |
