Difference between revisions of "SimuCUBE technical specifications"

From Granite Devices Knowledge Wiki
Jump to: navigation, search
[checked revision][checked revision]
(Power supply)
Line 37: Line 37:
 
! Input voltage  !! Input current when idle !! Input current max
 
! Input voltage  !! Input current when idle !! Input current max
 
|-
 
|-
| 24 - 55 VDC<sup>1</sup> || Typically < 0.4 A
+
| 20 - 55 VDC<sup>1</sup> || Typically < 0.4 A
 
|Depends on power driven to motor. Up to about 25 A peak consumption is possible. In typical cases 10A @ 48V is sufficient supply.
 
|Depends on power driven to motor. Up to about 25 A peak consumption is possible. In typical cases 10A @ 48V is sufficient supply.
 
|}
 
|}
Line 43: Line 43:
 
* SimuCUBE has an input diode for reverse input voltage protection
 
* SimuCUBE has an input diode for reverse input voltage protection
 
* Switching mode power supply (SMPS) and linear transformer based power supplies are directly suitable
 
* Switching mode power supply (SMPS) and linear transformer based power supplies are directly suitable
 +
 
===I/O===
 
===I/O===
 
All back face I/O connector pins of SimuCUBE are ESD protected.
 
All back face I/O connector pins of SimuCUBE are ESD protected.

Revision as of 23:16, 28 June 2016

Electrical

Please refer to IONI specifications for detailed information of the different IONI servo drive models.

Mechanical

Dimension drawing
Dimension Length
Width 160 mm
Depth 87.5 mm
Height < 50 mm (with IONI drive inserted)

Environmental

Property Value Units
Operating temperature 10-70 °C
Storage temperature -30-90 °C
Humidity 0-95 non-condensing  %

Note: on board IONI drive will require forced air flow cooling above 7 A output drive current.

Electrical

Power supply

Input voltage Input current when idle Input current max
20 - 55 VDC1 Typically < 0.4 A Depends on power driven to motor. Up to about 25 A peak consumption is possible. In typical cases 10A @ 48V is sufficient supply.

Notes:

  • SimuCUBE has an input diode for reverse input voltage protection
  • Switching mode power supply (SMPS) and linear transformer based power supplies are directly suitable

I/O

All back face I/O connector pins of SimuCUBE are ESD protected.

Property Connector/pins Value Unit
Button connection X12A/X12B Switch connected between input pin and GND pin
Button input pull-up voltage X12A/X12B 3.3 V
Button input pull-up resistance X12A/X12B 3.3 kOhm
Analog input voltage range X11A/X11B 0-3.3 V
Analog input impedance X11A/X11B > 10 kOhm
Analog input resolution X11A/X11B 12 bits
E-stop / Safe torque off input connection X1 pins 6-7 Normally closed (NC) switch connected between X1 pins 6 and 7

Motor control

SimuCUBE motor control is based on a IONI Servo & Stepper Drive that plugs on the provided socket. All motor control specifications are identical to IONI drive specifications. Refer to IONI specifications for details about:

  • Output current ratings
  • Supported Feedback devices
  • Heat dissipation & cooling
  • Fault protections