Difference between revisions of "Simucube 2 documentation"
| [checked revision] | [checked revision] |
(→Antenna connector / cable issues) |
(→Service manuals) |
||
| Line 11: | Line 11: | ||
'''Note: Review the instructions carefully and only perform service procedures if you feel comfortable performing them. Your reseller will always help if necessary.''' | '''Note: Review the instructions carefully and only perform service procedures if you feel comfortable performing them. Your reseller will always help if necessary.''' | ||
| + | ===Quick Release Pin is too tight or too loose=== | ||
| + | Problem: The Quick Release Pin is too tight or too easy to remove and QR has play. | ||
| + | Possible solution: Adjust the QR pin tightness. See video here: https://www.youtube.com/watch?v=YYKkb5Ioadg | ||
===Quick release slipping=== | ===Quick release slipping=== | ||
Problem: Wheel/quick release is slipping and center point is changing. | Problem: Wheel/quick release is slipping and center point is changing. | ||
Latest revision as of 11:49, 14 September 2021
This page lists all officially published documentation of Simucube 2 systems. The main Simucube 2 product website is at https:///www.simucu.be
Contents
Software[edit | edit source]
see Simucube 2 True Drive software releases
User manuals[edit | edit source]
Service manuals[edit | edit source]
Note: Review the instructions carefully and only perform service procedures if you feel comfortable performing them. Your reseller will always help if necessary.
Quick Release Pin is too tight or too loose[edit | edit source]
Problem: The Quick Release Pin is too tight or too easy to remove and QR has play. Possible solution: Adjust the QR pin tightness. See video here: https://www.youtube.com/watch?v=YYKkb5Ioadg
Quick release slipping[edit | edit source]
Problem: Wheel/quick release is slipping and center point is changing. Cause: The conical shaft adapter is slipping. This affected many of the very first produced Simucube 2 units in May 2019.
Device stuck at startup[edit | edit source]
Problem: Device stuck in "Waiting for drive to get ready" and does not start correctly. The E-stop button status follows the real e-stop button. Possible cause: Internal cable for the power button is placed in a bad/sensitive location inside the device. Note: This service instruction is only applicable to Simucube 2 Sport and Pro R1 units (Pro with 2 power supplies) that were produced before August 2020. R1 units have a rocker switch near the one of the rear corners as a power switch, where as R2 units have a on/off toggle switch near the center of the back plate.
Antenna connector / cable issues[edit | edit source]
Problem: The external antenna connector is loose. Cause: Loose antenna connector. Note: Do not spin the antenna connector to not cause the internal cable to wind up and break.
-
Simucube 2 Sport/Pro antenna connection retighten instructions (PDF) - Simucube 2 Ultimate antenna connector replacement / re-tightening guide (PDF)
Problem: Spinning antenna connector has caused the internal antenna cable to break. Solution: Replace the antenna connector&cable assembly. Contact your reseller for spare parts.
- Simucube 2 Sport/Pro R1 antenna connector replacement guide (PDF)
- Simucube 2 Sport/Pro R2 antenna connector replacement guide (PDF)
- Simucube 2 Ultimate antenna connector replacement / re-tightening guide (PDF)
