Difference between revisions of "IONICUBE 1X"
From Granite Devices Knowledge Wiki
| [checked revision] | [checked revision] |
(Created page with "{{Infobox drive | name = IONICUBE 1X | image=290px | modelno = IONICUBE 1X | drivetype = Single axis motherboard for IONI drives | motors =...") |
|||
| Line 33: | Line 33: | ||
* [[IONICUBE 1X connectors and pinouts]] | * [[IONICUBE 1X connectors and pinouts]] | ||
| + | ==See also== | ||
| + | * [[IONICUBE]] - 4 axis motherboard for IONI | ||
[[category:IONICUBE]] | [[category:IONICUBE]] | ||
[[category:Hardware]] | [[category:Hardware]] | ||
Revision as of 12:03, 31 March 2015
| IONICUBE 1X | |
|---|---|
 | |
| Device type | Single axis motherboard for IONI drives |
| Model number | IONICUBE 1X |
| Supported motors | AC, DC, BLDC, Linear |
| Control modes | Position, Velocity, Torque |
| Status | Active production, started 2015 |
| Electrical | |
| DC supply voltage | Same as IONI specifications |
| General | |
| Compliance | CE (EMC & LVD directives) |
| 3D model |
TBA |
Features
IONICUBE 1X has been designed robotics and automation systems in mind. On-board features include:
- Carry single IONI drive
- On-board regenerative braking resistor drive (need just an external resistor)
- Support mechanical end-of-travel switches and homing switch
- Motor holding brake output with driver
- 26 pin ribbon cable connector for I/O and setpoint signals
- Support 3.3V, 5V and 24V1 I/O signal levels
- Charge-pump enable input for safety
- E-stop switch input (safe torque off)
- ARGON Servo Drive compatible encoder connector pin-out
- RJ45 connectors for SimpleMotion V2 usage and configuration
- On-board 0.5A 5V regulator to power drive logic and feedback devices
- DIN rail mounting option
1) 24V I/O needs external components in certain cases
User guide
See also
- IONICUBE - 4 axis motherboard for IONI
