Difference between revisions of "IONICUBE 1X"
From Granite Devices Knowledge Wiki
[checked revision] | [checked revision] |
(→User guide) |
|||
Line 4: | Line 4: | ||
| modelno = IONICUBE 1X | | modelno = IONICUBE 1X | ||
| drivetype = Single axis motherboard for [[IONI]] drives | | drivetype = Single axis motherboard for [[IONI]] drives | ||
− | | motors = AC, DC, BLDC, Linear | + | | motors = AC, DC, BLDC, Linear, Stepper |
| controlmodes = Position, Velocity, Torque | | controlmodes = Position, Velocity, Torque | ||
| voltage= Same as [[IONI]] specifications | | voltage= Same as [[IONI]] specifications | ||
Line 42: | Line 42: | ||
==See also== | ==See also== | ||
* [[IONICUBE]] - 4 axis motherboard for IONI | * [[IONICUBE]] - 4 axis motherboard for IONI | ||
− | [[ | + | |
− | [[ | + | [[Category:Hardware]] |
+ | [[Category:IONICUBE]] |
Revision as of 11:05, 2 October 2015
IONICUBE 1X | |
---|---|
Device type | Single axis motherboard for IONI drives |
Model number | IONICUBE 1X |
Supported motors | AC, DC, BLDC, Linear, Stepper |
Control modes | Position, Velocity, Torque |
Status | Active production, started 2015 |
Electrical | |
DC supply voltage | Same as IONI specifications |
General | |
Compliance | CE (EMC & LVD directives) |
3D model |
TBA |
Contents
Features
IONICUBE 1X has been designed robotics and automation systems in mind. On-board features include:
- Carry single IONI drive
- On-board regenerative braking resistor drive (need just an external resistor)
- Support mechanical end-of-travel switches and homing switch
- Motor holding brake output with driver
- 20 pin ribbon cable connector for I/O and setpoint signals
- Support 3.3V, 5V and 24V1 I/O signal levels
- Charge pump enable input for safety
- E-stop switch input (safe torque off)
- ARGON Servo Drive compatible encoder connector pin-out
- RJ45 connectors for SimpleMotion V2 usage and configuration
- On-board 0.5A 5V regulator to power drive logic and feedback devices
- DIN rail mounting option
Applications
- Robotics
- CNC
- Distributed drive systems
- Racing simulators
1) 24V I/O needs external components in certain cases
User guide
See also
- IONICUBE - 4 axis motherboard for IONI