Difference between revisions of "IONICUBE 1X"
From Granite Devices Knowledge Wiki
| [checked revision] | [checked revision] |
| Line 27: | Line 27: | ||
*On-board 0.5A 5V regulator to power drive logic and [[feedback devices]] | *On-board 0.5A 5V regulator to power drive logic and [[feedback devices]] | ||
*DIN rail mounting option | *DIN rail mounting option | ||
| + | |||
| + | ==Applications== | ||
| + | *Robotics | ||
| + | *CNC | ||
| + | *Distributed drive systems | ||
| + | *Racing simulators | ||
<sup>1</sup>) 24V I/O needs external components in certain cases | <sup>1</sup>) 24V I/O needs external components in certain cases | ||
Revision as of 12:08, 31 March 2015
| IONICUBE 1X | |
|---|---|
 | |
| Device type | Single axis motherboard for IONI drives |
| Model number | IONICUBE 1X |
| Supported motors | AC, DC, BLDC, Linear |
| Control modes | Position, Velocity, Torque |
| Status | Active production, started 2015 |
| Electrical | |
| DC supply voltage | Same as IONI specifications |
| General | |
| Compliance | CE (EMC & LVD directives) |
| 3D model |
TBA |
Contents
Features
IONICUBE 1X has been designed robotics and automation systems in mind. On-board features include:
- Carry single IONI drive
- On-board regenerative braking resistor drive (need just an external resistor)
- Support mechanical end-of-travel switches and homing switch
- Motor holding brake output with driver
- 26 pin ribbon cable connector for I/O and setpoint signals
- Support 3.3V, 5V and 24V1 I/O signal levels
- Charge-pump enable input for safety
- E-stop switch input (safe torque off)
- ARGON Servo Drive compatible encoder connector pin-out
- RJ45 connectors for SimpleMotion V2 usage and configuration
- On-board 0.5A 5V regulator to power drive logic and feedback devices
- DIN rail mounting option
Applications
- Robotics
- CNC
- Distributed drive systems
- Racing simulators
1) 24V I/O needs external components in certain cases
User guide
See also
- IONICUBE - 4 axis motherboard for IONI
