Device connection troubleshooting

This article helps finding cure for connection problems between PC and drive.

Granity

Granity requires following to establish connection:

• Compatible RS485 adapter, such as SimpleMotion V2 USB Adapter
• SimpleMotion V2 compliant drive, such as Argon
• SimpleMotion V2 calbing with termination
• Correct bus address setting on all devices in the SM V2 bus, see Setting device bus address

Typical errors

• Bus address conflicting between devices (two or more devices set to same address)
• Missing bus termination
• Device has an error state, see led indicators
• Wrong communication interface device selected from Granity

GDtool, DCtool and VSD-E/XE

Some most common resons for failing GDtool connection with VSD-E and VSD-XE:

• Cable to CMD connector is connected simultaneously when USB adapter is plugged in (CMD connector should be left unconnected while using GDtool to prevent communication interference because these connectors have shared signals)
• Wrong software being used for the installed firmware. Use only GDtool for single axis firmware and only DCtool for DualDC firmware. If you accidentally used wrong tool, re-flash the firmware file to reset all drive settings to factory state.
• Electromagnetic interference (EMI). If connection breaks when HV voltage is applied to drive (and works fine when only 12V is applied), then it is probably cause by electromagnetic interference. Typical reasons:
  • Motor output cable is not shielded and shield not connected to drive FG (frame ground)
  • Motor casing (metal) not connected to drife FG via cable shield or earthing connector.
  • Interference escaping from power supply leads
  • Interference escaping from other nearby equipment such as VFD or welding machine
  • EMI suppression cores on motor, power & USB cable may help
• Device power-up sequence not properly done during establishing connection
• USB adapter may have been damaged. Damage may occur with voltage potential error or when used with CMD cable plugged simultaneously. Also DOA cables have been the reason in rare cases (less than 0.5%).

More things to try:

• Try on another computer
• Try on isolated system with only one drive, 12V power supply and a computer. Preferably far from EMI sources.

In no event the Product Information or parts hereof shall be regarded as guarantee of conditions or characteristics. The Product Information or any part thereof may also not be regarded as a warranty of any kind. No liability of any kind shall be assumed by Author with respect to Product Information or any use made by you thereof, nor shall Author indemnify you against or be liable for any third party claims with respect to such information or any use thereof.

As content of this Wiki may be edited by user community, Granite Devices Oy or it's affiliates do not take any responsibility of the contents of this Wiki. Use information at your own risk. However, Granite Devices staff attempts to review all changes made to this Wiki and keep information trustworthy.

Without written consent, Granite Devices' Products or Intellectual Property shall not be used in situations or installations where living beings, material property, or immaterial property could be harmed by the operation, features or failures of Product. Products may only be used in a way where hazards like moving parts, electric shock, laser radiation, or fire can't be realized even if the content of this Wiki would suggest otherwise.