Difference between revisions of "Argon temp"

[checked revision]

Revision as of 08:38, 31 August 2017

Please check out articles under following categories:

Motor compatibility guide - how to determine whether a motor works with a drive
IONI device model comparison - what are the differences between models
Fault location - error codes that indicate reason for a device fault state
Setting up parellel motors (two motors driving one gantry) - how to setup parallel axis system
Splitting encoder signal - how to share encoder signal between many devices
Dual-loop feedback position control - how to make dual-feedback system
Hard-stop homing - how to configure sensorless homing
Regenerative resistor - what is it and how to select one
Using stepping motor with IONI - how to configure a stepping motor
Drive fault handling - how drive handles faults
Argon supply voltage troubleshooting - what are the reasons if undervoltage fault seems permanent
Device connection troubleshooting - what are the reasons if connection can't be established

@@ Line 2: / Line 2: @@
 |- style="height:150px;"
 | style="text-align:center; width: 200px;" |[[Argon firmware releases|Firmware releases]][[Image:Firmware main page.jpg|link=Argon firmware releases|centre|frameless|120x120px]]
-| style="text-align:center; width: 200px;" |[[ARGON Servo Drive|Introduction]][[Image:Feedback main page.jpg|link=ARGON Servo Drive|centre|frameless|120x120px]]
+| style="text-align:center; width: 200px;" |[[ARGON Servo Drive|Introduction]][[Image:Introduction icon.jpg|link=ARGON Servo Drive|centre|frameless|120x120px]]
 | style="text-align:center; width: 200px;" |[[Argon specifications|Specifications]][[Image:Specs icon.jpg|link=Argon specifications|centre|frameless|120x120px]]
 | style="text-align:center; width: 200px;" |[[:Category:Argon troubleshooting|Troubleshooting]][[Image:Troubleshooting icon.jpg|link=Category:Argon troubleshooting|centre|frameless|120x120px]]