Difference between revisions of "IONICUBE"
From Granite Devices Knowledge Wiki
| [checked revision] | [checked revision] |
| Line 10: | Line 10: | ||
| agencies=CE (EMC & LVD directives) | | agencies=CE (EMC & LVD directives) | ||
| 3dmodel=[[Media:IONICUBE drawings 2d 3d.zip|IGES, STEP, 2D PDF]] | | 3dmodel=[[Media:IONICUBE drawings 2d 3d.zip|IGES, STEP, 2D PDF]] | ||
| + | | url=[https://granitedevices.com/ionicube-multiaxis-servo-drive-boards/ Granite Devices IONICUBE] | ||
}}{{IoniManualNav|width=22em|notoc=1}} | }}{{IoniManualNav|width=22em|notoc=1}} | ||
Revision as of 22:29, 28 June 2016
| IONICUBE | |
|---|---|
 | |
| Device type | 4 axis motherboard for IONI drives |
| Model number | IONICUBE |
| Supported motors | AC, DC, BLDC, Linear, Stepper |
| Control modes | Position, Velocity, Torque |
| Status | Active production, started 2015 |
| Electrical | |
| DC supply voltage | Same as IONI specifications |
| General | |
| Web site | Granite Devices IONICUBE |
| Compliance | CE (EMC & LVD directives) |
| 3D model | |
IONICUBE is a 1-4 axis motherboard for IONI Servo Drives. IONICUBE provide four slots for IONI drives as well as terminals and connectors for motor power, feedback devices, I/O and SimpleMotion V2.
Features
IONICUBE has been designed multiaxis robotic systems such as CNC machines in mind. On-board features include:
- Carry up to 4 IONI drives
- On-board regenerative braking resistor
- Support end-of-travel switches and homing switches
- Motor holding brake outputs & drivers for each axis
- Two 26 pin I/O and setpoint signal connectors
- X4 connector is directly connectible to traditional CNC controllers (parallel port, SmoothStepper etc).
- X5 connector for extra I/O for drives and analog setpoint inputs for custom applications
- No separate break-out-boards needed
- Charge pump enable input for safety
- E-stop switch input (safe torque off)
- PWM to 0-10V converter for VFD spindle
- Two drivers for external relays
- ARGON Servo Drive compatible encoder connector pin-out
- RJ45 connectors for SimpleMotion V2 usage and configuration
- On-board 1.5A 5V regulator to power drive logic and feedback devices
User guide
See also
- IONICUBE 1X - a single axis motherboard for IONI
