Difference between revisions of "Argon user guide/J3 connector wiring"
From Granite Devices Knowledge Wiki
| [checked revision] | [checked revision] |
(Created page with "Argon's J3 is a 3 pole terminal block type connector used for supplying 24VDC to drive and optionally controlling motor solenoid brake. ==Pin-out== {| class="wikitable" |- ! P...") |
|||
| (4 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | Argon's J3 is a 3 pole terminal block type connector used for supplying 24VDC to drive and optionally controlling motor solenoid brake. | + | {{SetAUGTitle|J3 connector wiring}}{{ArgonManualNav}}Argon's J3 is a 3 pole terminal block type connector used for supplying 24VDC to drive and optionally controlling motor solenoid brake. |
==Pin-out== | ==Pin-out== | ||
{| class="wikitable" | {| class="wikitable" | ||
| Line 16: | Line 16: | ||
Brake output is optional and may be left unconnected if brake is not present in the axis. | Brake output is optional and may be left unconnected if brake is not present in the axis. | ||
[[File:Argonwiringoverview.png|800px]] | [[File:Argonwiringoverview.png|800px]] | ||
| + | [[Category:Argon wiring]] | ||
Latest revision as of 13:44, 6 December 2013
Argon's J3 is a 3 pole terminal block type connector used for supplying 24VDC to drive and optionally controlling motor solenoid brake.Pin-out[edit | edit source]
| Pin # | Pin name | Description | Connection |
|---|---|---|---|
| 1 | BK | Motor brake output | If motor has a 24V solenoid brake, connect brake between BK and V+ |
| 2 | V+ | 24V supply positive input | Connect to 24V PSU + |
| 3 | V- | 24V supply ground, on J1, J2.x and J5 connectors tied to GND | Connect to 24V PSU - |
24VDC typical current consumption is between 0.1 - 0.7ADC depending on how much current is drawn by feedback device and an optional motor brake.
Wiring guide[edit | edit source]
Brake output is optional and may be left unconnected if brake is not present in the axis.
