Difference between revisions of "Argon user guide/J3 connector wiring"

Revision as of 19:21, 18 August 2013 (edit) Tero K (Talk | contribs) ← Older edit	Latest revision as of 13:44, 6 December 2013 (edit) (undo) Tero K (Talk | contribs)
(One intermediate revision by the same user not shown)
(No difference)

---

Latest revision as of 13:44, 6 December 2013

Argon general pages

---

• About Argon servo drive
  • Specifications
• Glossary
• Troubleshooting

---

Argon user guide

---

• Argon user guide
  • List of things needed
  • Making the first Granity connection
    • Setting device bus address
  • Wiring
    • Protective earthing
    • Mating connectors and accessories
    • J1: Feedback device wiring
    • J2: Stop button, enable and SimpleMotion wiring
    • J3: Logic power & brake wiring
    • J4: AC power, motor and braking resistor wiring
    • J5: I/O, setpoint and switches wiring
  • LED status indicators
  • Drive parameterization
    • Granity user guide
    • Servo motor tuning guide
  • Using Argon with LinuxCNC

Contents

• 1 Pin-out
• 2 Wiring guide

Argon's J3 is a 3 pole terminal block type connector used for supplying 24VDC to drive and optionally controlling motor solenoid brake.

Pin-out[edit | edit source]

Pin #	Pin name	Description	Connection
1	BK	Motor brake output	If motor has a 24V solenoid brake, connect brake between BK and V+
2	V+	24V supply positive input	Connect to 24V PSU +
3	V-	24V supply ground, on J1, J2.x and J5 connectors tied to GND	Connect to 24V PSU -

24VDC typical current consumption is between 0.1 - 0.7ADC depending on how much current is drawn by feedback device and an optional motor brake.

Wiring guide[edit | edit source]

Brake output is optional and may be left unconnected if brake is not present in the axis.