Difference between revisions of "Argon user guide/Drive parameterization"

From Granite Devices Knowledge Wiki
Jump to: navigation, search
[checked revision][checked revision]
(Created page with "{{SetAUGTitle|Drive parameterization}}{{ArgonManualNav}} This article will describe how to set-up Argon parameters with Granity to make motor operational and ready for [...")
 
Line 1: Line 1:
{{SetAUGTitle|Drive parameterization}}{{ArgonManualNav}}
+
{{SetAUGTitle|parameterization}}{{ArgonManualNav}}
 
This article will describe how to set-up Argon parameters with [[Granity]] to make motor operational and ready for [[[[Servo motor tuning guide|servo tuning]]]].
 
This article will describe how to set-up Argon parameters with [[Granity]] to make motor operational and ready for [[[[Servo motor tuning guide|servo tuning]]]].
 
==Preparations and connection==
 
==Preparations and connection==

Revision as of 21:32, 23 August 2013

This article will describe how to set-up Argon parameters with Granity to make motor operational and ready for [[servo tuning]].

Preparations and connection

As the goal is to parameterize and make motor operational, we should have:

  1. The drive and motor fully wired. However it's not required to have controller (to J5 port) or braking resistor connected at this point.
  2. Be familiar with the operation and parameters of Granity. Make sure you have read Granity user guide.
  3. Granity connection working. See Making the first Granity connection

Setting initial parameters