Difference between revisions of "Argon user guide/Drive parameterization"
From Granite Devices Knowledge Wiki
| [checked revision] | [checked revision] |
(Created page with "{{SetAUGTitle|Drive parameterization}}{{ArgonManualNav}} This article will describe how to set-up Argon parameters with Granity to make motor operational and ready for [...") |
|||
| Line 1: | Line 1: | ||
| − | {{SetAUGTitle| | + | {{SetAUGTitle|parameterization}}{{ArgonManualNav}} |
This article will describe how to set-up Argon parameters with [[Granity]] to make motor operational and ready for [[[[Servo motor tuning guide|servo tuning]]]]. | This article will describe how to set-up Argon parameters with [[Granity]] to make motor operational and ready for [[[[Servo motor tuning guide|servo tuning]]]]. | ||
==Preparations and connection== | ==Preparations and connection== | ||
Revision as of 21:32, 23 August 2013
This article will describe how to set-up Argon parameters with Granity to make motor operational and ready for [[servo tuning]].
Preparations and connection
As the goal is to parameterize and make motor operational, we should have:
- The drive and motor fully wired. However it's not required to have controller (to J5 port) or braking resistor connected at this point.
- Be familiar with the operation and parameters of Granity. Make sure you have read Granity user guide.
- Granity connection working. See Making the first Granity connection
