Setting device bus address

All SimpleMotion V2 compatible devices have a settable address that identifies the device on a multidrop communication bus. Each device sharing the same bus must have an unique address number to make error free communication possible. For example configuring bus address is required to establish a connection with Granity software.

Argon

DIP switch of Argon. In this case the DIP has value 01001.

Argon (servo drive) has a 5 channel DIP switch that sets the address. The table below lists all possible settings of DIP switch settings. Switches 1-4 set the address and the switch number 5 sets termination on or off.

Address	Bus termination	DIP switch setting (switches from 1 to 5)
255 (firmware upgrade mode)	Off	00000
255 (firmware upgrade mode)	On	00001
1	Off	00010
1	On	00011
2	Off	00100
2	On	00101
3	Off	00110
3	On	00111
4	Off	01000
4	On	01001
5	Off	01010
5	On	01011
6	Off	01100
6	On	01101
7	Off	01110
7	On	01111
8	Off	10000
8	On	10001
9	Off	10010
9	On	10011
10	Off	10100
10	On	10101
11	Off	10110
11	On	10111
12	Off	11000
12	On	11001
13	Off	11010
13	On	11011
14	Off	11100
14	On	11101
15	Off	11110
15	On	11111

Bus termination

Proper configuration of devices on a bus

SimpleMotion V2 bus must be terminated for reliable communication. This means that last device of the bus must have termination DIP switch set to On position.

Bus may be also alternatively terminated with external 100 ohm resistor connected between RS485_A and RS485_B wires at the end of bus cable chain (see SimpleMotion V2 port). If DIP switch termination is used, then drive internal 100 ohm resistor is connected across the A and B wires.

Stub

If an E-stop button is connected with RJ45 cable after the last device, a bus stub is formed. Stub must not be longer than 30 cm or 1 foot to ensure reliable bus operation.

Methods to eliminate the stub on SimpleMotion V2 port cable E-stop cable if longer than 30cm E-stop cable is needed:

• Cut the RS485_A and RS485_B wires from the cable near connector, this ends the RS485 bus next to connector and minimizes stub
• Alternatively, connect termination resistor at end of RS485_A and RS485_B wires and set DIP switch termination off

Troubleshooting

Following errors may cause unreliable connection:

• If two or more devices have same address on a single bus
• If termination is missing or is present multiple times
• If bus stub is too long

In no event the Product Information or parts hereof shall be regarded as guarantee of conditions or characteristics. The Product Information or any part thereof may also not be regarded as a warranty of any kind. No liability of any kind shall be assumed by Author with respect to Product Information or any use made by you thereof, nor shall Author indemnify you against or be liable for any third party claims with respect to such information or any use thereof.

As content of this Wiki may be edited by user community, Granite Devices Oy or it's affiliates do not take any responsibility of the contents of this Wiki. Use information at your own risk. However, Granite Devices staff attempts to review all changes made to this Wiki and keep information trustworthy.

Without written consent, Granite Devices' Products or Intellectual Property shall not be used in situations or installations where living beings, material property, or immaterial property could be harmed by the operation, features or failures of Product. Products may only be used in a way where hazards like moving parts, electric shock, laser radiation, or fire can't be realized even if the content of this Wiki would suggest otherwise.