Difference between revisions of "SimuCUBE technical specifications"

From Granite Devices Knowledge Wiki
Jump to: navigation, search
[checked revision][checked revision]
(Mechanical)
Line 1: Line 1:
 
{{SimucubeManualNav}}  
 
{{SimucubeManualNav}}  
 
== Mechanical ==
 
== Mechanical ==
[[File:Simucube dimensions.png|thumb|Dimension drawing]]
+
[[Simucube dimensions.png|thumb|Dimension drawing]]
 
{| class="wikitable"
 
{| class="wikitable"
 
!Dimension
 
!Dimension
Line 15: Line 15:
 
|< 50 mm (with IONI drive inserted)
 
|< 50 mm (with IONI drive inserted)
 
|}
 
|}
 
+
2D PDF and DXF files can be found here:
 +
* [[file:simucube_small_case_pdf_dxf.zip]]
 +
* [[file:simucube_big_case_pdf_dxf.zip]]
 
== Environmental ==
 
== Environmental ==
 
{| class="wikitable"
 
{| class="wikitable"
Line 69: Line 71:
 
* Fault protections
 
* Fault protections
  
[[Category:SimuCUBE_user_guide]]
 
 
[[Category:SimuCUBE]]
 
[[Category:SimuCUBE]]
 +
[[Category:SimuCUBE_user_guide]]

Revision as of 10:27, 9 August 2016

Mechanical

thumb|Dimension drawing

Dimension Length
Width 160 mm
Depth 87.5 mm
Height < 50 mm (with IONI drive inserted)

2D PDF and DXF files can be found here:

Environmental

Property Value Units
Operating temperature 10-70 °C
Storage temperature -30-90 °C
Humidity 0-95 non-condensing  %

Note: on board IONI drive will require forced air flow cooling above 7 A output drive current.

Electrical

Power supply

Input voltage Input current when idle Input current max
20 - 56 VDC1 Typically < 0.4 A Depends on power driven to motor. Up to about 25 A peak consumption is possible. In typical cases 10A @ 48V is sufficient supply.

Notes:

  • SimuCUBE has an input diode for reverse input voltage protection
  • Switching mode power supply (SMPS) and linear transformer based power supplies are directly suitable

I/O

All back face I/O connector pins of SimuCUBE are ESD protected.

Property Connector/pins Value Unit
Button connection X12A/X12B Switch connected between input pin and GND pin
Button input pull-up voltage X12A/X12B 3.3 V
Button input pull-up resistance X12A/X12B 3.3 kOhm
Analog input voltage range X11A/X11B 0-3.3 V
Analog input impedance X11A/X11B > 10 kOhm
Analog input resolution X11A/X11B 12 bits
E-stop / Safe torque off input connection X1 pins 6-7 Normally closed (NC) switch connected between X1 pins 6 and 7

Motor control

SimuCUBE motor control is based on a IONI Servo & Stepper Drive that plugs on the provided socket. All motor control specifications are identical to IONI drive specifications. Refer to IONI specifications for details about:

  • Output current ratings
  • Supported Feedback devices
  • Heat dissipation & cooling
  • Fault protections