Difference between revisions of "Template:ArgonManualNav"
From Granite Devices Knowledge Wiki
| [checked revision] | [checked revision] |
| (60 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | <div style="margin-bottom: | + | <span class="noprint"><div style="margin-bottom: 10px;margin-left:10px;float:right;margin-right:0px;width:{{{width|260px}}};clear:right;"> |
| − | + | ||
| − | + | ||
| − | + | ||
| − | <noinclude> | + | <div class="metadata gdnavbox"> |
| + | <center>Argon general pages</center> | ||
| + | ---- | ||
| + | *[[ARGON Servo Drive|About Argon servo drive]] | ||
| + | **[[Argon specifications|Specifications]] | ||
| + | *[[:Category:Glossary|Glossary]] | ||
| + | *[[:Category:Argon troubleshooting|Troubleshooting]] | ||
| + | ---- | ||
| + | <center>Argon user guide</center> | ||
| + | ---- | ||
| + | *[[Argon user guide]] | ||
| + | **[[Argon user guide/List of things needed|List of things needed]] | ||
| + | **[[Argon user guide/Making the first Granity connection|Making the first Granity connection]] | ||
| + | ***[[Setting device bus address]] | ||
| + | **[[Argon user guide/Wiring|Wiring]] | ||
| + | ***[[Argon_user_guide/Earthing|Protective earthing]] | ||
| + | ***[[Argon user guide/Mating connectors and accessories|Mating connectors and accessories]] | ||
| + | ***[[Argon user guide/J1 connector wiring|J1: Feedback device wiring]] | ||
| + | ***[[SimpleMotion V2 port|J2: Stop button, enable and SimpleMotion wiring]] | ||
| + | ***[[Argon user guide/J3 connector wiring|J3: Logic power & brake wiring]] | ||
| + | ***[[Argon user guide/J4 connector wiring|J4: AC power, motor and braking resistor wiring]] | ||
| + | ***[[Argon user guide/J5 connector electrical interfacing|J5: I/O, setpoint and switches wiring]] | ||
| + | **[[Argon user guide/LED indicators|LED status indicators]] | ||
| + | **[[Argon user guide/Drive parameterization|Drive parameterization]] | ||
| + | ***[[Granity user guide]] | ||
| + | ***[[Servo motor tuning guide]] | ||
| + | **[[Using Argon with LinuxCNC]] | ||
| + | </div> | ||
| + | {{#if:{{{notoc|}}}| |<div style="float:right">__TOC__</div> }} | ||
| + | </div><noinclude> | ||
{{doc}} | {{doc}} | ||
[[Category:Utility templates|{{PAGENAME}}]] | [[Category:Utility templates|{{PAGENAME}}]] | ||
| Line 11: | Line 37: | ||
</categorytree> | </categorytree> | ||
| − | </noinclude> | + | HUOM class metadata estää tämän tulemisen pdf:ään, muut konstit ei tepsiny |
| + | |||
| + | <categorytree mode=all style="">Argon</categorytree> | ||
| + | [[Category:Exclude in print]]</noinclude></span> | ||
