Difference between revisions of "About SimuCUBE"
From Granite Devices Knowledge Wiki
| [checked revision] | [checked revision] |
| Line 15: | Line 15: | ||
{{warning|This section is unfinished. Don't use until this notice is removed.}} | {{warning|This section is unfinished. Don't use until this notice is removed.}} | ||
| + | |||
| + | ==Features== | ||
| + | SimuCUBE has been designed around the [[IONI]] servo drive, and the features include: | ||
| + | * Up to 25 A continuous current with IONI Pro HC. | ||
| + | * On-board [[regenerative resistor|regenerative braking resistor]]. | ||
| + | * On board ARM processor will run the FFB firmware of user choice (such as the popular MMos firmware, or a new upcoming GPL licensed open source FFB firmware. | ||
| + | |||
[[File:Simucube chart.png|thumb|Simplified chart of a SimuCUBE FFB simulator setup.|400px|center]] | [[File:Simucube chart.png|thumb|Simplified chart of a SimuCUBE FFB simulator setup.|400px|center]] | ||
Revision as of 11:01, 12 May 2016
| SimuCUBE | |
|---|---|
 | |
| Device type | Single axis motherboard for IONI drives |
| Model number | SimuCUBE |
| Supported motors | AC, DC, BLDC, Linear, Stepper |
| Control modes | Position, Velocity, Torque |
| Status | Active production, started 2016 |
| Electrical | |
| DC supply voltage | Same as IONI specifications |
| General | |
| Compliance | CE (EMC & LVD directives) |
| 3D model |
TBA |
SimuCUBE is a state-of-the-art direct drive force feedback controller. Essentially a motherboard for an IONI servo drive, the SimuCUBE offers easiest solution and the best price-quality ratio for simulator professionals and enthusiasts.
 | This section is unfinished. Don't use until this notice is removed. |
Features
SimuCUBE has been designed around the IONI servo drive, and the features include:
- Up to 25 A continuous current with IONI Pro HC.
- On-board regenerative braking resistor.
- On board ARM processor will run the FFB firmware of user choice (such as the popular MMos firmware, or a new upcoming GPL licensed open source FFB firmware.
Links and miscellaneous notes
If you are not using a ready configuration file for Granity, then please read servo tuning basics and torque tuning very carefully to get the idea how it's done. Every servo type requires specific parameters.
Please read also these pages to get the best possible experience of a SimuCUBE FFW system.
Availability
Coming soon to our web store.
