Difference between revisions of "Main Page"
From Granite Devices Knowledge Wiki
| [checked revision] | [checked revision] |
(Tag: VisualEditor) |
|||
| (3 intermediate revisions by the same user not shown) | |||
| Line 38: | Line 38: | ||
</div> | </div> | ||
</div> | </div> | ||
| + | |||
| + | <div class="mainpageproductdocbox"> | ||
| + | <div class="mainpageproductdocbox_header"> | ||
| + | ===Simucube=== | ||
| + | </div> | ||
| + | <div class="mainpageproductdocbox_content"> | ||
| + | ;[[SimuCUBE|Simucube 1]] | ||
| + | ;[[Simucube 2 documentation|Simucube 2]] | ||
| + | </div> | ||
| + | </div> | ||
| + | |||
| + | |||
<div class="mainpageproductdocbox"> | <div class="mainpageproductdocbox"> | ||
<div class="mainpageproductdocbox_header"> | <div class="mainpageproductdocbox_header"> | ||
| Line 103: | Line 115: | ||
<div style="clear:both;padding:10px;"></div> | <div style="clear:both;padding:10px;"></div> | ||
| − | |||
</div> | </div> | ||
Latest revision as of 19:59, 24 April 2020
Welcome to Granite Devices Wiki. This page serves as Granite Devices' official documentation platform for all of our products. The wiki is based on same platform as Wikipedia allowing users to modify and enhance its contents.
Navigate using the categories and links below, or browse the list of all pages.
Product documentation
Servo & stepping motor drives
- Specifications
- Model comparison
- User guide
- Firmware upgrades
- IONICUBE 4 axis IONI motherboard
- IONICUBE 1X single axis IONI motherboard
Motors
Simucube
Laser diode drives
Software
Most viewed pages
Help articles
Please check out articles under following categories:
- Hardware - learn about drives and motors
- Software - learn about setup and control software
- Setup guides - learn how to configure products
- Troubleshooting - find a solution to a problem
- Glossary - learn about terminology and technology
Frequently asked questions
- Motor compatibility guide - how to determine whether a motor works with a drive
- IONI device model comparison - what are the differences between models
- Fault location - error codes that indicate reason for a device fault state
- Setting up parellel motors (two motors driving one gantry) - how to setup parallel axis system
- Splitting encoder signal - how to share encoder signal between many devices
- Dual-loop feedback position control - how to make dual-feedback system
- Hard-stop homing - how to configure sensorless homing
- Regenerative resistor - what is it and how to select one
- Using stepping motor with IONI - how to configure a stepping motor
- Drive fault handling - how drive handles faults
- Argon supply voltage troubleshooting - what are the reasons if undervoltage fault seems permanent
- Device connection troubleshooting - what are the reasons if connection can't be established
